0

Kenmore Washing Machine Error Codes

Kenmore Washing Machine Error Codes

Kenmore Washing Machine Error Codes

Washing Machine is useful Product from Every home And it is a product used in every home Sometimes it contains an error code. We can fix some error codes at home and we need to call a technician to fix some error codes. In this post you will find all the error codes of Wenmore washing machine and I hope you will benefit a lot from this post. If you find it helpful, please share this post.

Error CodesPossible CausesSolutions
03Drain pump filter clogged.
Drain hose is bent, pinched, or clogged.
Drain pump failed.
Check and clean drain pump filter.
Make sure the drain hose is free of clogs, kinks, etc., and is not pinched behind or under the washer.
Call for service.
L3Water supply taps are not open fully.
Water line hoses are kinked, pinched, or bent.
Water inlet filters are clogged.
Water pressure to tap or house is too low.
Make sure that the water taps are open fully.
Make sure the hoses are not kinked or pinched. Be careful when moving the washer.
Clean the inlet filters. See the Care and Cleaning section.
Check another faucet in the house to make sure that household water pressure is adequate.
dEThe lid is not closed properly.Make sure that the lid is closed properly and press the START/PAUSE button. After starting a cycle, it may take a few moments before the tub begins to turn or spin. The washer will not spin unless the lid is locked.
If the lid is closed and locked and the open lid error message is displayed, call for service.
If you press the START button while the lid is open, dE error message will be displayed.
dLLid lock switch errorMake sure that the lid is closed properly and press the START/PAUSE button. The washer will not spin unless the lid is locked.
If the lid is closed and the lid lock error message is displayed, call for service.
FEWater level is too high due to a faulty water valve.Close the water taps, unplug the washer, and call for service.
E6Clutch errorMechanical failure.
Unplug the washer, and call for service
UELoad is too small.
Load is out of balance.
Add 1 or 2 similar items to help balance the load.
Rearrange items to help balance the load.
The washer has an imbalance detection and correction system. If individual heavy articles are loaded (bath mat, bath robe, etc.) and the imbalance is too great, the washer will make several attempts to restart the spin cycle. If an imbalance is still detected, the washer will stop and the error code will be displayed.
tEThermistor errorThe water temperature sensor is faulty. Unplug the washer and call for service.
PEThe water level sensor is not working correctly.Close the water taps, unplug the washer, and call for service.
LEThermal overload protection circuit in the motor has been tripped.Allow the washer to stand for 30 minutes to allow the motor to cool; then restart the cycle. If the LE error code still appears, unplug the washer and call for service.

Kenmore Washing Machine Manual PDF

Whirlpool Refrigerator ARB-884SGYS Electric Diagram

HVAC Solution