0

Zanussi Refrigerator Error Codes

Share
Zanussi Refrigerator Error Codes

Zanussi Refrigerator Error Codes

Refrigerator is useful Product for Every home And this product used in every home. Sometimes it contains an error code. We can fix some error codes at home and we need to call a technician to fix some error codes. In this post you will find all the error codes of Zanussi Refrigerator and I hope you will benefit a lot from this post. If you find it helpful, please share this post.

Error CodesMeaning
Normal – SHFresh Food Sensor Shorted
E2Room temperature sensor damaged (installed on the display board)
t3TH3 Sensor (open or short) Go to flow chart for Ice t3
E0No error
E50 degree compartment sensor damaged
SY – EFEvaporator Fan Failure
Erhttp://IM/RAM Error. Check J4-4, J4-5 and J4-6 Connector on Icemaker board. Check J4 connector at Main Control board. Check 15 pin inline connector at control board, Pin#’s 4,9 & 14. If all connections test good, control board.
CEIM Com Lost Go to flow chart 50C. Put into service mode to verify.
SY – CFCommunication Failure
OP – NormalFreezer Sensor OPEN
SH – NormalFreezer Sensor SHORTED
E4Room temperature sensor damaged (installed on the power board)
E1Evaporator sensor damaged
Normal – OPFresh Food Sensor OPEN
SY – CECommunication Error

Zanussi Refrigerator Troubleshooting

ProblemPossible CauseSolution
No power to the applianceNo power at the socket.Check there is power at the socket.
There is a power cut.Check there is not a power cut by checking the household lights.
The fuse has blown.Check the fuse has not blown.
Thermostat control knob is set at „0”.Check the thermostat setting
The temperature in the fridge or freezer is too highThe appliance is located in an unsuitable position.Check the ambient temperature is within the appliances operating limits of 10 °C to 32 °C.
The thermostat control knob is set too low.Check that the thermostat control knob is turned to the correct setting relative to ambient conditions.
The compressor runs continuouslyThe thermostat control knob is set at the wrong temperature.Adjust the thermostat control knob.
The door is open.Close the door.
Large quantities of food have been placed in the cabinet.Close the door.
The door has been opened too frequently.Do not leave the door open longer than necessary.
The air ventilation is obstructed.Check that the air ventilation is not obstructed.
The temperature in the fridge or freezer is too lowThe thermostat control knob is set too cold.Set the thermostat control knob to a warmer position.
Excessive frost and ice has built upThe door has been left open.Check the door has not been left open.
Something is obstructing the doorCheck nothing is preventing the door from closing.
The door gasket is dirty.Check the door gasket is intact and clean.
The appliance is noisyThe appliance is not level.Check if the appliance stands stable on the floor.

if you use a refrigerator, you must protect and care for your refrigerator so that your refrigerator performs well in cooling.
The refrigerator should be placed in a place where there is ventilation (ventilation mean = Air Crossing).
If you want to read more about Zanussi refrigerators, download the PDF file from the link below. You will find a lot Information in this PDF file.

Zanussi Refrigerator Manual PDF

Whirlpool Refrigerator ARB-884SGYS Electric Diagram

HVAC Solution

HVAC work is dangerous. So we should get life and Health insurance