Refrigeration & Air Conditioner | Fully4world - Part 2

Category: Refrigeration & Air Conditioner

How to Uninstall Split AC (Air Conditioner)

How to Uninstall Split AC (Air Conditioner) Before uninstall any Split Air Conditioner we should Store his Gas. Tools we need for Uninstall Air Conditioner: L Key 4mm or 5mm , 2 Screw Wrench, Screw Driver, Plier Turn On AC and set Temperature at 18°C  When Turn on the Outdoor we should Close his Discharge

Gas Store, R600, Long Pipe, Question and Answer ?

Q1. How much is R600 Gas Running Pressure and Standing Pressure? Ans. R600 Running  Pressure is 0 Psi to 2 Psi and Standing Pressure is 40 Psi to 50 Psi. Q2. What we can Attach 2 Ton indoor Unit with 1.5 Ton Outdoor unit ? Ans. Yes we can Attach 2 Ton indoor with 1.5

How to Trace fault with Gas Pressure & Line Gauge

How to Trace fault with Gas Pressure & Line Gauge We can Trace some fault with running and standing pressure. when AC is turn ON then the pressure that appears on the gauge is Running Pressure and when AC is turn OFF then the pressure that appears on the gauge is Standing Pressure. R22 Normal

3 Phase AC use 4 pool magnetic contactor

3 Phase AC use 4 pool magnetic contactor 4 pole and 5 pole magnetic contactor use in 3 phase units. we should always use magnetic contactor in 3 phase because magnetic contactor control the wire when the magnetic contactor is off so that magnetic contactor will not Pass electricity 1 point to 2nd point When

AC drain Block Water fall in the room

AC drain Block Water fall in the room If water drop fall in the room then which type of problem we can face, mostly people face this problem before service AC and mostly people face this problem After service AC.  i have already upload some article about water fall in the room: AC water Drops

How to find Transformer Input and Output & test Transformer

Find Transformer Input and Output If we have a transformer and we don’t know that which is Output and which is Input don’t worry we can find easily with Multimeter. Every transformer have 2 input wires and 2 output. we should set Multimeter on Continuity and check 2 wires, which 2 wires show more resistance

R32 Use and Risk|FAQ’s R32 by Toshiba

FAQ’s R32 Why is R32 Required? The Main Pillars of the new EU F-Gas Rules are to reduce emissions and to move towards lower GWP solutions. This involves a phase down in the consumption of HFCs and a reduction of 37% by 2020 and 79% by 2030. By 2025 Single Split A/C systems with less

How to Check rotary Compressor that Damage or not

How to Check rotary Compressor If we have a rotary compressor and we don’t know it’s bad or not. we should check his short that this compressor is short or not. Multimeter set on buzzer and one wire of multimeter attach with compressor body and second wire of multimeter attach with compressor terminal one by

How to change Direct Cool Refrigerator Thermostat

How to change Direct Cool Refrigerator Thermostat A thermostat is a component which senses the temperature of a physical system and performs actions so that the system’s temperature is maintained near a desired set point. i am use always VT9 thermostat we should open his thermostat cover and see thermostat connection and do again same

Before buy old AC Should know some information

Before buy old AC Should know some information When we buy a second hand AC we should check some important things. we should always check that which AC we are buying That AC is not near a Cloaca (dirty drain) because Cloaca (dirty drain) effect on copper and The AC gets repeatedly leaked. We should check