Tag: ac error codes list

Changhong Ruba DC inverter Error Code

Changhong Ruba DC inverter Error Code List Read and Fix Problems  F1 Indoor Room Temperature Sensor Fault F2 Outdoor Discharge Temperature Sensor Fault F3 Indoor Coil Temperature Sensor Fault F4 Indoor Fan Motor Faukt F4 Outdoor Section Line Temperature Sensor Fault F5 Gas Pressure High or Low F6 Communication Fault Between indoor to Outdoor HVAC

AC Compressor wiring burn and installed new wires

AC Compressor wiring burn and installed new wires Sometimes our AC’s every thing ON but do not Cooling Outdoor fan running but Outdoor compressor not running sometimes our compressor burn but sometimes our Compressor wiring burn And the compressor survives. in this Condition that our wiring burn we should take off the old wires new

Indoor air throw low Reasons and Solve Problems

Indoor air throw low Reasons and Solve Problems If our AC’s indoor air throw is low Then the ice comes on the suction pipe. Indoor air throw low have many reasons.  If our AC need Service (Evaporator is dirty) If Blower is dirty If Blower motor is damaged If Blower motor capacitor is damaged Air

E4, E5, E6 Error Code in non Inverter AC Solve

E4, E5, E6 Error Code in non Inverter AC Solve Some Non Inverter AC don’t  show error Code but some show error in LED. When we see E4 error in non Inverter then we should check his indoor Blower Motor we should disconnect wire his blower motor from PCB and again Connect and check that

Crrier DC inverter Error Code list

The error message is shown at the OUTDOOR UNIT CONTROLLER as following table: Outdoor Temperature Sensor Failure Ambient temperature sensor E0 Inlet coil temperature sensor E1 Suction temperature sensor E2 Mid coil temperature sensor E3 DLT Digital Compressor sensor E4 Outdoor Status Error Communication error between indoor & outdoor unit controllers [E High pressure status

F1 & H6 Error Solved (Gree AC) 2019

Solve Fault F1 & H6 Error Code Gree non Inverter AC Error F1 & H6 Solved. I checked an AC that’s show F1 & H6 Error. Don’t worry. Just open PCB Board from indoor and check the coil Sensor and room Temperature Sensor. But when i Open PCB i saw that Room Temperature Sensor is