Amana Washing Machine Error Codes
Washing Machine is useful Product from Every home And it is a product used in every home Sometimes it contains an error code. We can fix some error codes at home and we need to call a technician to fix some error codes. In this post you will find all the error codes of Amana washing machine and I hope you will benefit a lot from this post. If you find it helpful, please share this post.
| LED Display | Description |
|---|---|
| nd | The water level fails to drop below the Low Water level reset within 15 minutes, before a spin begins. Diagnostic code: 1 |
| LO | Door failed to unlock after 3 attempts. Diagnostic code: 2 |
| nF | Continuous fill of 12 minutes. Total fill of 14 minutes. Diagnostic code: 3 |
| FL | Door failed to lock after 3 attempts. Diagnostic code: 4 |
| LE | Water sensor level fault. Diagnostic code: 8 |
| OE | A fault is detected in the water level sensor. Data (frequency) shows the water level is at or above the overflow level. Diagnostic code: E |
| E2 | A key is sensed to be pressed more than 30 seconds, the key will be assumed to be stuck. Diagnostic code: 15 |
| dc | Never exceeded 400 rpm due to an unbalanced load. Diagnostic code: 10 |
| od | The door has not been opened after two complete wash cycles. Door switch was not seen open since the last two final spins. Diagnostic code: 17 |
| dL | Open door lock switch with motor running. Diagnostic code: 18 |
| dS | Door switch is read as open and the door locked switch is read as locked. Diagnostic code: 22 |
| bE | Motor tach signal exists without motor running. Diagnostic code: 25 |
| tE | Abnormal high/low temp or ohm resistance seen. Diagnostic code: 29 |
| E3 | Machine control is attempting to drive the motor but is not seeing any tach response. Visual check shows motor is not moving. (Locked, Hall Sensor fault) Diagnostic code: 2E |
| Sr | System Relay failure. Diagnostic code: 34 |
| 3E | Over Current is detected. Motor won’t turn. Diagnostic code: 3E |
| 2E | Voltage for motor control bus is over specified limit. Diagnostic code: 91 |
| 2E | Voltage for motor control bus is under specified limit. Diagnostic code: 92 |
| dET | Detergent cartridge not detected in the dispenser. |
| Int | The cycle was paused or canceled. |
| rL F34 | Items were detected in the washer during the Clean Washer cycle. |
| Sud or Sd | There are too many suds in the washing machine. |
| F5 E2 | The door is not locking properly. |
| F7 E1 | Indicates a motor speed sensing error. |
| F8 E1 or LO FL | The washer is sensing a low flow of water. |
| F8 E2 | Indicates there is a problem with the Dispenser System |
| F9 E1 | Indicates that drain times are longer than expected, typically over eight (8) minutes. |
| Other F# E# code | Indicates other error |
