Kitchenaid Refrigerator Error Codes
Refrigerator is useful Product for Every home And this product used in every home. Sometimes it contains an error code. We can fix some error codes at home and we need to call a technician to fix some error codes. In this post you will find all the error codes of Kitchenaid Refrigerator and I hope you will benefit a lot from this post. If you find it helpful, please share this post.
|When power has been restored, “PO” repeatedly flashes on the control panel display. All other control and dispenser functions are disabled and “PO” will continue to blink until you acknowledge the power outage. Press the MEASURED FILL button to confirm. The Power Outage icon “PO” will disappear, and the control panel will return to the Normal screen.
|Door Ajar Alarm
|The Door Ajar Alarm feature sounds an alarm when the refrigerator door(s) or freezer drawer is open for 5 minutes and cooling is turned on. The alarm will repeat every 2 minutes. Close all doors and drawer to turn it off. The feature then resets and will reactivate when either door is left open again for 5 minutes.
|Back and 1 Cup
|Press and hold the OPTIONS and LOCK buttons at the same time for 3 seconds. The words “Back” and “1 Cup” will appear on the display screen. Also, the Calibrate Measured Fill icon will illuminate and remain lit while the Measured Fill feature is being calibrated.
|The dispenser can be disabled for easy cleaning or to avoid unintentional dispensing by small children and pets. NOTE: The lock feature does not shut off power to the refrigerator, to the ice maker, or to the dispenser light. It simply deactivates the controls and dispenser levers. To turn off the ice maker, see “Ice Maker and Storage Bin.” Press and hold LOCK for 3 seconds to lock the dispenser.
Kitchenaid Refrigerator Troubleshooting
|Operating Sound Level
|See owners manual for explanation of normal operating sound
|Freezer Warm – Compressor Off
|Temperature Control defective or setting too warm
|Too Cold in Refrigerator
|Refrigerator damper control knob set too cold
|Freezer Warm – Compressor Cuts Off on Overload
|Heavy usage and/or high ambient
|Freezer Too Warm – Compressor Operating
|Control knob set too warm
|Too Warm in Refrigerator
|Refrigerator setting too warm
|Freezer Too Cold
|Freezer temperature control knob set too cold
|Long Off Cycle – Too Warm at Start
|Low ambient temperature
|Short off Cycle
|High ambient and/or heavy usage
|Long or Continuous Operation
|Heavy usage and/or high ambient
|Short Run Cycle
|Low ambient and/or light usage
|Condensation on Cabinet Exterior
|High humidity installation (design accepts bead of water onexterior of cabinet after 4 hours with a 0° to 5°F. (-18° to -17°C.)freezer food temperature and 38° to 40°F. (3°C to 4°C) refrig-erator food temperature in 84% R.H. conditions
|No Ice/Low Ice Production
|Freezer not cold enough
|Over Production of Ice
|Bail shut-off arm not in actuator
|Hollow Ice Cubes
|Water fill volume too low
|Flooding or Ice Slabs in Bucket or Freezer
|Thermostat out of calibration
if you use a refrigerator, you must protect and care for your refrigerator so that your refrigerator performs well in cooling.
The refrigerator should be placed in a place where there is ventilation (ventilation mean = Air Crossing).
If you want to read more about Kitchenaid refrigerators, download the PDF file from the link below. You will find a lot Information in this PDF file.