Zanussi Washing Machine Error Codes

Zanussi Washing Machine Error Codes

Zanussi Washing Machine Error Codes

Washing Machine is useful Product from Every home And it is a product used in every home Sometimes it contains an error code. We can fix some error codes at home and we need to call a technician to fix some error codes. In this post you will find all the error codes of Zanussi washing machine and I hope you will benefit a lot from this post. If you find it helpful, please share this post.

Error CodesProblem
E10Inlet water overtime. Open the water tap, to check if the inlet hose is squashed or kinked, check if the filter in the inlet valve is blocked or not; check if the water pressure is too low.
E21Overtime of the drainage. Check if the drain pump is blocked.
E30The door has not been closed. Check if the door of the washing machine is closed check if the clothes are trapped by the door seal.
E50Voltage is too high. Check if the voltage is too high if it is this case, a constant voltage device is needed.

Zanussi Washing Machine Troubleshooting

MalfunctionPossible Cause / Solution
The washing machine does not work.Close the washing machine’s door. Press the Start/Pause key.
Water leakageCorrectly connect the inlet water pipe.
The spin of the clothes is abnormalReload and distribute the laundry evenly in the drum.
There is the peculiar smell in the washing machineRun a Self-clean cycle without any clothes.
No water is visible in the drumNo fault-water is under the visible area.
There is the remaining water in the softener’s boxNo fault- the effect of the softener will not be affected.
The remaining detergent is left on the clothesThe water-fast component of the non-phosphorus detergent will be left on the clothes to form into spot. Please select «Rinse&Spin» programme. or brush away the fleck after the clothes is dried.
The washing machine does not fillTurn on the water tap. Check the selection of the procedure Reconnect the water inlet pipe. Check if the water pressure is sufficient. Check if the inlet water pipe is bent or blocked. Close the washing machine’s door.
The washing machine fills and drains at the same time.Make sure the end of the drainage pipe is higher than the water level inside the machine . Check if the drainage pipe and waste have been sealed.
The washing machine does not drainCheck if the drainage pumps is blocked. Check if the drainage pipe is bent or blocked. Check the height of the drainage nozzle, make sure it is 0.6-1 meter high from the bottom of the washing machine.
Vibration of the washing machineLevel the washing machine. Fasten the footing. Check if all the delivery bolts have all been removed.
The machine stops when the proce- dure has not been finishedPower failure or water cut.
The drainage pump is noisy during operation after the water has been drainedThe water inside the inner barrel has been drained but there is still a small amount of water in the drainage pump and pipe. The drainage pump continuously work and takes in the air, then there wil be noise which is normal situation.
The machine stops for some time during the wash procedureThe washing machine adds water automatically. There is too much foam in the tube, the foam is being drained.

Zanussi Washing Machine Manual PDF

Whirlpool Refrigerator ARB-884SGYS Electric Diagram

HVAC Solution

Leave a Reply

Your email address will not be published.