Hitachi Washing Machine Error Codes
Washing Machine is useful Product from Every home And it is a product used in every home Sometimes it contains an error code. We can fix some error codes at home and we need to call a technician to fix some error codes. In this post you will find all the error codes of Hitachi washing machine and I hope you will benefit a lot from this post. If you find it helpful, please share this post.
| Error Codes | Solution |
|---|---|
| C01 | Water is not supplied. Check water tap, water inlet filter, water line and water hose. |
| C02 | Water is not drained. Check drain hose, drain pump and drain outlet. If C02 still appears after removing the possible cause, please contact your local service center for repair. |
| C03 | The door is open. Make sure the door stopper is retracted. |
| C04 | Spin cycle does not function. Add a few clothes to the drum. (Spinning only one item may result in imbalance.) |
| C08 | Door lock does not function. Check the door and close firmly. |
| C09 | Door unlock does not function. Laundry may be exceeded 8 kg and door is pushed from inside. Switch power off and press the door to close tightly. Hold that position and switch power on, and wait until the door lock is released. |
| C14 | Malfunction of vibration sensor. There may be other appliances that generate electrical noise near the washing machine. Move the appliances away from the washing machine. |
| C18 | Spin cycle does not function. The drain hose may not be set correctly. There may be too much foam in the drum. Same as in C02 & C20. |
| C19 | Over loaded. Laundry may exceed rated capacity. |
| C20 | Drum does not rotate. To eliminate the excessive foam, switch off the washing machine and wait for about 30 mins, then switch on again and select Rinse & Spin without adding detergent. |
| C30 | Water flows out from drain hose while washing. Drain hose end is set lower than 60 cm. |
| CH | The spinning speed is not reached the speciļ¬ ed value. Check the amount of powder detergent putting, check the drain hose and installation of drain hose. |
| CO | Laundry overload. Decrease the laundry. |
| CF | CF means communication fault |
| FL | Verify that the water is turned on. |
Hitachi Washing Machine Troubleshooting
| Problem | Possible cause |
|---|---|
| Does not operate | The power plug is not inserted in the power outlet. There is a power outage. The Delay Timer has been set. |
| It is wet, even though it is the fi rst time to use it (drain hose, tub, etc.) | There may be moisture or water left in the tub or hoses from the performance test before shipping from the factory. |
| The remaining time increases during operation | The remaining time is adjusted to compensate for the speed of the incoming water. |
| Water is added again during the washing process | Water is added automatically up to the set water level if the water level falls because water is absorbed by the laundry. |
| Wash time is longer than the time that was set manually | If the water pressure is low, the operating time may increase due to a longer water supply time. |
| The washing machine stops during the spin cycle and starts adding water | If the laundry is extremely off balance when the spin cycle starts, the spin cycle stops and the rinse cycle starts to rebalance the laundry. After the load is rebalanced, the spin cycle starts again. |
| During the spin cycle, the tub spins increasingly faster | This is to more effi ciently remove water. |
| Sound of water is heard when the tub moves | That is the sound of water in the Liquid Load Balancer, which is used for balancing when the tub is spinning. |
| The tub does not fi ll up when water is added from a bucket | Turn on the power. When the power is turned on the drain valve closes and you can fi ll the tub with water. |
| The lid does not open | When the lid lock indicator is lit, the lid is locked and cannot be opened. |
| The strength of water fl ow does not change in spite of changing the indicator | It may not change the strength of water flow according to the process and the load amount. It is not abnormal |
Hitachi Washing Machine Manual PDF
My Hitachi washing machine giving CC error. When we start after 3 second water pump stop working and giving CC error