Liebherr Refrigerator Error Codes

Liebherr Refrigerator Error Codes

Liebherr Refrigerator Error Codes

Refrigerator is useful Product for Every home And this product used in every home. Sometimes it contains an error code. We can fix some error codes at home and we need to call a technician to fix some error codes. In this post you will find all the error codes of Liebherr Refrigerator and I hope you will benefit a lot from this post. If you find it helpful, please share this post.

Error CodesMeaning
BT011Refrigerator compartment air sensor
BT021Refrigerator compartment evaporator sensor
BT031Freezer compartment air sensor. Compressor continuous operation
BT071Ambient air sensor. Ambient temperature is specified
GQ033Base compartment fan
PH00XCommunication error
PZ001UI hardware
PZ002UI memory
E0Temperature sensor defective. Contact the customer service department.
EEElectronic control system error
EFElectronic control system error
dOrAppliance door open for too long. Close appliance door
E1Temperature sensor defective. Contact the customer service department.
HITemperature inside appliance too high (too warm). Check that the door has been closed properly. If the temperature does not drop, contact the customer service department.
LOTemperature inside appliance too low (too cold)
rETemperature sensor defective. Contact the customer service department.
HF, HAThere has been a power cut of some length or the interior was too warm or too cold during a certain period of time.
AFrTemperature around the product sensor < 0°C
E2Temperature sensor defective. Contact the customer service department.

Ambient sensor error is only tested and displayed in the operating panel test of the Customer Service mode.

Liebherr Refrigerator Troubleshooting

ProblemPossible Cause and Remedy
Appliance does not work, display is off– Is the appliance turned on properly? – Is the power cord properly inserted in the outlet? – Is the circuit breaker or fuse in operating condition?
The interior light does not come on– Is the refrigerator compartment turned on? – Has the door been open for more than 15 minutes?
Loud running noiseIs the appliance standing firmly on the floor, or does the compressor cause nearby items of furniture or objects to vibrate? If necessary, move the appliance slightly, align by adjusting the adjustable feet, or adjust bottles and containers.
Motor seems to run too long– Is the ambient temperature too hot? See Safety Regulations. – Has the appliance been opened too often or left open too long? – A large amount of food has been added. – Unit is in SuperCool mode. Verify unit is in normal operation mode.
The temperature is not cold enough– Is the temperature setting correct? – Has an excessive amount of fresh food been placed in the appliance? – Does a separately installed thermometer show the correct reading? – Is the ventilation system working properly? – Is the appliance set up too close to a heat source?
Freezer temperature display shows two dashes – –The freezer temperature display will only show temperatures that are below freezing. When initially starting the freezer it will not be below freezing. It will take three to five hours (depending on ambient conditions) for freezing temperatures to be achieved and thus displayed numerically. This may also occur after a power failure.
Ice or water drops appear on the rear wall in the interior of the refrigerator compartmentThis is completely normal. During the cooling process, the humidity in the refrigerator compartment will condense on the rear wall and freeze. During the compressor idle period, the ice layer will defrost. The condensate on the rear wall drains through the defrost water drain for evaporation.
Ice maker cannot be turned onIs the combined refrigerator-freezer connected to the electrical outlet?
Ice maker is not making any ice– Is the ice maker turned on? – Is the IceMaker drawer closed properly? – Is there enough water in the water tank? – Has the water tank been inserted correctly?
The control lamp above the ON/OFF button flashes– Is there enough water in the water tank? – Has the water tank been inserted correctly?

If you use a refrigerator, you must protect and care for your refrigerator so that your refrigerator performs well in cooling.
The refrigerator should be placed in a place where there is ventilation (ventilation mean = Air Crossing).
If you want to read more about Liebherr refrigerators, download the PDF file from the link below. You will find a lot Information in this PDF file.

Liebherr Use and Care Manual For NoFrost Combined Refrigerator-Freezers PDF

Liebherr Refrigerator Service Manual PDF

Liebherr Refrigerator Service Manual PDF – Combined fridge-freezer with Smart Frost- Appliance Documentation Cef 3405-4025

Whirlpool Refrigerator ARB-884SGYS Electric Diagram

HVAC Solution

Leave a Reply

Your email address will not be published.