Sharp Washing Machine Error Codes

Error Code	Problem OR Solution
E1	Low flow at the faucet. Inclease water supply, press START / PAUSE key.
	The faucet is closed. Turn the faucet on, press START/PAUSE key.
	Water inlet filter net is blocked. Clean filter net, press START/PAUSE key
E2	Top cover is opened as the reservation course starts. Close top cover.
	Top cover is not closed during spin drying. Close top cover.
E3	The drain position is relatively high. Adjust drain hose properly, press START/PAUSE key
	The end of drain hose is blocked. Clean drain hose, press START/PAUSE key.
	Drain hose is folded/ crumpled/tied. Clean drain hose, press START/PAUSE key.
E4	Washing machine inclines or is shaky. Washing machine place the horizontally with adjusting the foots
	The clothing is lopsided. Distribute the clothing evenly
E5	Draining position is relatively high. Lower down the drain hose, press START/PAUSE button.
	Drainage hose is frozen or blocked. Defreeze/unblock drainage hose, press START/PAUSE button.
	Drainage hose is bent, squeezed, tangled. Smooth out drainage hose, press START/PAUSE button.
E7	Lid do not close when safety lock is on. Close the lid in 10s and program will resume itself; if lid is still open after 10s, machine will start draining. To resume, deselect SAFETY LOCK mode.
C2	Water level sensor shows an abnormal level. Water level sensor shows an abnormal level.
U9	Top cover opened in the situation of CHILD LOCK. Turn the power off, and take it from the top. CHILD LOCK is not released, unless you reset it manually

Error Code	Possible Failure	Solution
E01	The door is not shut properly	Shut the door properly so that you hear the click
E02	The water level in your machine may be low, or the water pressure may be low	Check that the cold water tap is fully turned on
E03	The pump has failed, or the pump filter is obstructed	Check that the cold water tap is fully turned on
E04	There is an excessive amount of water in your Washing Machine	Your Washing Machine will automatically drain the water. Turn your Washing Machine off, unplug it and contact the Sharp helpdesk
	There is no water supply or the mains water pressure is low	Check mains water supply is on and has sufficient pressure. If the mains supply has been cut off, switch the control dial to Stop and re-select the programme once the supply has been restored.
	Faulty pump or clogged pump filter	The pump filter may be clogged. Check and clean if necessary

PROBLEM	CHECK POINT
	• Did you connect the inlet hose and open the water tap? • Is the inlet hose or the water tap frozen? • Is the water supply shut off? • Does foreign matter block up the inlet hose filter?
	• Is the drain hose frozen or blocked up by dirt? • Is the drain hose kinked or deformed? • Is the end of the drain hose immersed in water? • Is there excessive dirt inside the pump housing?
	• Is the clothes in the tub collected on one side? • Is the washing machine installed on an uneven floor or is the vibration serious? • Is the lid open? (The lamp LE will light up in this case.)
The washer will not operate at all.	• Is there a power failure? • Is the power cord correctly connected to an electric outlet? • Is the electric fuse broken? • Did you turn on the power? • Did you press Start/Pause button? • Is there correct amount of water in the tub?