ac fan | Fully4world

Tag: ac fan

AC Compressor wiring burn and installed new wires

AC Compressor wiring burn and installed new wires Sometimes our AC’s every thing ON but do not Cooling Outdoor fan running but Outdoor compressor not running sometimes our compressor burn but sometimes our Compressor wiring burn And the compressor survives. in this Condition that our wiring burn we should take off the old wires new

Indoor air throw low Reasons and Solve Problems

Indoor air throw low Reasons and Solve Problems If our AC’s indoor air throw is low Then the ice comes on the suction pipe. Indoor air throw low have many reasons.  If our AC need Service (Evaporator is dirty) If Blower is dirty If Blower motor is damaged If Blower motor capacitor is damaged Air

E4, E5, E6 Error Code in non Inverter AC Solve

E4, E5, E6 Error Code in non Inverter AC Solve Some Non Inverter AC don’t  show error Code but some show error in LED. When we see E4 error in non Inverter then we should check his indoor Blower Motor we should disconnect wire his blower motor from PCB and again Connect and check that

Gas Store, R600, Long Pipe, Question and Answer ?

Q1. How much is R600 Gas Running Pressure and Standing Pressure? Ans. R600 Running  Pressure is 0 Psi to 2 Psi and Standing Pressure is 40 Psi to 50 Psi. Q2. What we can Attach 2 Ton indoor Unit with 1.5 Ton Outdoor unit ? Ans. Yes we can Attach 2 Ton indoor with 1.5

How to Trace fault with Gas Pressure & Line Gauge

How to Trace fault with Gas Pressure & Line Gauge We can Trace some fault with running and standing pressure. when AC is turn ON then the pressure that appears on the gauge is Running Pressure and when AC is turn OFF then the pressure that appears on the gauge is Standing Pressure. R22 Normal

How to Check rotary Compressor that Damage or not

How to Check rotary Compressor If we have a rotary compressor and we don’t know it’s bad or not. we should check his short that this compressor is short or not. Multimeter set on buzzer and one wire of multimeter attach with compressor body and second wire of multimeter attach with compressor terminal one by

How to change Direct Cool Refrigerator Thermostat

How to change Direct Cool Refrigerator Thermostat A thermostat is a component which senses the temperature of a physical system and performs actions so that the system’s temperature is maintained near a desired set point. i am use always VT9 thermostat we should open his thermostat cover and see thermostat connection and do again same

Light blink error Solve problem|Error code

Light blink error Old model of AC light blink error, indoor unit is ON but power supply not reach outdoor. When we see this error then we should change his room temperature and coil sensor if his sensor is OK then remove his sensor Jack and re apply if not solve this problem then his