Marq by Flipkart Washing Machine Error Codes : Washing Machine is useful Product from Every home And it is a product used in every home Sometimes it contains an error code. We can fix some error codes at home and we need to call a technician to fix some error codes. In this post you will find all the error codes of Marq By Flipkart washing machine and I hope you will benefit a lot from this post. If you find it helpful, please share this post.
| Error Codes | Solution |
|---|---|
| E01 | Water inlet timeout. Open tap then check if the water inlet hose are kinked. Check if the water inlet valve screens is clogged. Check if the home has low water pressure. Check if the fixed cap drop off. |
| E04 | Washer Drain timeout. Check if pump is stuck. Check if the top of drain hose lower than 60cm. |
| E05 | Door is open. Check if door is pinned by the door. Check if the door of the washing machine is closed. |
| E00 | Other errors. Try again. Please contact your local service center. if the problem persists. |
Marq by Flipkart Washing Machine Troubleshooting
| Problems | Solutions |
|---|---|
| Washer does not start | Close door completely. Make sure plug fits tightly in wall outlet. Confirm the Power and Start/Pause button have been pressed. |
| Water leaks | Check and tighten hose connections unclog drain pipes. |
| Washer won’t spin or load too wet after spin | Rearrange load to allow proper spinning. Add 1 or 2 similar items to help balance the load. |
| Door does not open | Once started, the door can not be opened for safety reasons. Wait one or two minutes before opening the door to allow the electric locking mechanism time to release. |
| Washer odor | Using Drum Clean without laundry. |
| Water not visible in the drum | Not a fault-The water lies below the visible part of the drum. |
| Detergent residue in the detergent drawer. | Clean and dry the detergent dispenser. |
| Water does not enter washer or it enters slowly | Check another tap in the house. Wait until water supply and pressure increase. Fully open tap. Avoid running water elsewhere while washer is filling. Straighten hoses. |
| Water is entering washer but tub does not fill | Increase standpipe height to at least 23.6” (60 cm). Check if sewer has been sealed with the drain hose, if it has been,there will be the poor ventilation to cause the siphonage. |
| Water in washer does not drain or drains slowly | Clean and straighten the drain hose. Unclog drain pipes. Contact plumber if necessary. The drain hose should not be placed higher than 100 cm above the floor. |
| Vibrating noise | Move washer so it rests firmly on floor. Adjust leveling legs. Stop washer and rearrange wash load. |
| Oversudsing | Run rinse cycle. Use a low-sudsing, high efficiency detergent. Run rinse cycle. Use less detergent in future loads. |
| The machine stops when the programme haven’t finished | Power failure or water cut. |
| The pump has noise just when the water in drum fully be drained | Although water in drum has been drained, there is still a small amount of water in the pump and outlet hose. The pump continuously works and draws in air, which is the noise source. This is normal situation. |
| Drum stop for some time during running | The washer adds water automatically to the foam detection feature has activated to reduce the amount of foam. |
Marq by Flipkart Washing Machine Fully Automatic Front Load Instruction Manual PDF
I’m washing machine technician
Marq front load washing machine is throwing error E01. Please get the problem solved. 9849013591.
Rajeev nagar Hyderabad 45 beside Jasmine High School
This is washing machine technician from vijayawada can u get me 7995831183